Please use this identifier to cite or link to this item:
|Title:||Full-scale cold bending demonstration test||Authors:||Gergess, Antoine
|Affiliations:||Department of Civil and Environmental Engineering||Keywords:||Cold bending
|Issue Date:||2007||Part of:||Journal of constructional steel research||Volume:||63||Issue:||10||Start page:||1295||End page:||1304||Abstract:||
A new, innovative cold bending procedure was developed by a US fabricator to economically meet tolerance requirements for the curved steel girders used in the Miami Metro-Mover. Based on the procedures used by the fabricator, the authors developed approximate analytical solutions relating loads to residual deformation when curving unstiffened or vertically stiffened, symmetrical or non-symmetrical girders. This paper assesses the accuracy of the theoretical solutions by comparing its predictions with results from a full-scale demonstration test. In the test, a vertically stiffened 12.88 m (42ʹ–3″) long girder was curved to a radius of 115.5 m (379ʹ). The predictions from the analyses for the applied loads and lateral offsets were both within 10–15% of the experimental results.
|URI:||https://scholarhub.balamand.edu.lb/handle/uob/2023||DOI:||10.1016/j.jcsr.2006.11.015||Ezproxy URL:||Link to full text||Type:||Journal Article|
|Appears in Collections:||Department of Civil and Environmental Engineering|
Show full item record
checked on Oct 23, 2021
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.